Where this is not possible, the existing cable has to be extended using our ‘M’ version of the required cable which has a male connector that will plug into the female connector of the USB Blaster. If the existing cable can be unplugged and replaced with the Tag-Connect™ cable, this is always the preferred solution. Some devices such as the EthernetBlaster II have the connector available on the outside of the case so replacement is even simpler. The Terasic USB Blaster is an example of where the case can be opened and the existing cable replaced with a Tag-Connect™ cable. You may have to open the case of the USB Blaster to check this. The required Tag-Connect™ solution depends on whether or not the target board connection cable that is supplied with the unit can be unplugged or whether it is hard soldered into the internal circuit board. These include the Altera USB Blaster, the Altera USB Blaster II, the Terasic USB Blaster and the Altera Ethernet Blaster. The family of Intel Altera USB Blasters, clones and similar products share the same 10-pin pinout for target board connection.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |